Your How To Info

How To Make Your Home Solar Powered

If you are looking for a way to lower your energy bills each month, a solar power home kit might be the answer. If you want to reduce the amount of money you pay on your electric bills then recent advances in solar panel design has made this technology an effective method to do so. By utilizing a solar power system you can replace up to all of of your electricity by using the sun, and you don’t have to pay for power any more.

Solar systems are simple to set up and are offered in a wide variety of different configurations. Most of the job can be done by the homeowner and an electrician only needs to hook up the cables to their home’s power supply. If you want to pass the inspection you will have to hire a electrician because of specific codes that have to be closely followed.

The first thing you should do before buying a solar power kit is to determine your homes power requirements. You can do this by reviewing your power bills. You need to look for your highest power usage and also figure out your average usage for the year.

This will allow you to decide on which sized system is right for you. Also, most of the modern solar power home systems enable you to install a basic setup with a few panels and then add more each year as your budget permits. This can be handy since you can spread the cost out over several years instead of having to finance it all the first year.

The two important parts of a solar system is the solar panel and the power inverter. A rail system will hold the solar panels secure, and keep them a few inches up off the surface of the roof. You do this to make sure rain and debris doesn’t get stuck in the panels and that they are fully ventilated. To ensure that they are secure as possible you should anchor the rails to the roof joists. The panels will need to be supported properly because even though modern panels are lighter than previous models, they still can be quite heavy.

After the solar panels are assembled and in place you can run the cables down to the spot where the inverter will be located. The inverter will switch the currency from DC, which the solar panels produce, to AC, which is the format that all homes run with. Both exterior and interior models of inverters are offered.

If you went with an exterior inverter you only have to run the cables to where the inverter will sit. If you are going to use an interior inverter you may need to have an electrician route the cables because certain electrical codes must be followed. Once you have laid out and mounted the power cables they need to be connected to the electrical system of your home.

You might have to find an electrican to do it for you, and it would be helpful if they knew about installing solar power systems. Once this is complete, you are ready to enjoy years of lower electrical bills as your solar power home kit converts sunlight into savings.

For more information on solar powered homes please visit http://www.residentialrenewableenergy.com/solar-power-home.php